No flaking, no peeling
Easy to apply
Money-back guarantee
20k+ projects protected
SHIMISPART Rapid Protective Coating
- Rapid cure, 100% solids structural polyaspartic coating for fast, reliable surface protection.
- Hardens in about 30 minutes at 25°C and can return to service the same day.
- Moisture tolerant, self levelling, clear and tintable with SHIMICOAT tints, metallics and flake.
- Simple 1.5:1 mix ratio, applied by roller, brush or squeegee.
Description
SHIMISPART™ Rapid Protective Coating is a high performance, moisture tolerant, structural polyaspartic coating for fast, reliable surface protection. It is a two component, 100% solids clear resin that hardens in about half an hour at 25°C, giving a smooth, seamless, hard wearing finish that can be returned to service the same day.
The same resin forms the basis of SHIMISPART Rapid Repair: where a trowellable mortar is needed rather than a coating, Super Ceramic filler can be added to produce a paste of the required consistency.
Typical Uses
- Rapid cure protective coating for concrete floors and prepared substrates
- Seal and build coat where a fast return to service is required
- Protective coating over repaired or patched areas
- Binder for decorative and slip resistant broadcast materials
- Plant rooms, workshops, warehouses and trafficked areas
Kit Sizes
- Mini 1.25 Lt: 0.75 Lt Part A resin + 0.5 Lt Part B hardener
- Small 2.5 Lt: 1.5 Lt Part A resin + 1 Lt Part B hardener
- Medium 5 Lt: 3 Lt Part A resin + 2 Lt Part B hardener
- Large 7.5 Lt: 4.5 Lt Part A resin + 3 Lt Part B hardener
- XL 12.5 Lt: 7.5 Lt Part A resin + 5 Lt Part B hardener
- XXL 25 Lt: 15 Lt Part A resin + 10 Lt Part B hardener
Key Features
- Rapid cure: tack free in 15 minutes at 25°C, ready to grind in about 30 minutes, recoat after 1 hour
- 100% solids: no solvent, no VOC and no shrinkage on cure
- Moisture tolerant: tolerates damp substrates with no standing water
- Smooth seamless finish: self levelling on horizontal surfaces, clear, hygienic and easily cleaned
- Tintable and decorative: accepts SHIMICOAT tints, metallics, flake and glitter
- Strong: coating strength typically greater than 50 MPa when fully cured
Coverage is approximately 0.2 Lt per square metre per coat, around 5 square metres per litre. All polyaspartic coatings may yellow slightly over time: overcoat with SHIMISPART Topcoat UV Shield where long term colour stability outdoors is required. Full application detail is in the Technical Data Sheet under Downloads & Guides below.